Checkline MST Manuel d'utilisateur télécharger pdf (Page 20)

4.1 WINDOWS Terminal Program

The measured values and the mem-

ory contents can be transmitted over

the RS-232 interface to a personal

computer. You can connect the com-

puter to the connector of the MST

by using the ET2-CC special cable

which is available as an accessory.

The pin assignment of the connector

is described in Chapter 2.2.

Requirement:

A communication program, such as

Terminal or HyperTerminal (provided

on MS Windows Version 3.0 or later)

must be installed and configured on

the computer.

4 PC Communication (RS-232-C Interface)

4.2 TENSION INSPECT ET2-P1

SCHMIDT software (Win 95 or higher) for viewing and storing the measured data on a PC

(optionally available).

Commands for communication with a PC (polling)

ASCII

Code

Function Description

Continuous

transmission

Continuous trans-

mission of read-

ings.

Press any key to

stop transmission.

d Send

Transmit current

reading to PC

once.

m Save

Start logging of

measured data.

Stop data logging.

r Output

Output the memory

contents to the PC.

Clear

memory

Delete the memory

contents.

Damping

ON / OFF

Switch damping on

or off.

z Zero

Carry out zero

adjustment of the

instrument.

1 2 ... 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Checkline MST Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Checkline MST